SNDC

Heating and Air-conditionig Equipement manufacturer
Thermal comfort and air quality

Electrical air conditioner

 

| SKIMO RANGE | Installation | SKIMO 80V |

 

SKIMO 80V : Required furniture to install

SKIMO : 274B58
  • 2mm² (80V) or 10mm² cables to connect the SKIMO unit to the battery: 1 black cable for the ground and one red cable for the plus, equipped with 2 M6 terminals to connect to the Skimo unit and with 2 terminals to connect to the battery or alternator.
    /!\ The section of cables must be increased for lengthes superior to 5 m.
  •  

  • 1mm² cable to connect the SKIMO unit to the alternator D+ output (that signals that the engine is running), equipped with a 1-way “FASTON” type connector (male casing – female terminal) on one end and a terminal to connect to the D+ signal on the other end.
  •  

  • A fuse-casing and a 20A (80V).
  •  

  • Some silicone rubber to seal the roof and the unit.

 

An optional electric connection set including the above mentioned components (except the silicon tube) is available under the SNDC reference: 274B78 (80Volts).

 

Converter 12VDC in case of absence of 12VDC on the machine

To supply electrical power to the 12VDC components of SKIMO A/C unit, an optional 12VDC is available under the SNDC reference263A02.

SKIMO 80V - converter 12V : code 263A02

 

 

 

 

Converter 24VDC in case of absence of 24VDC on the machine

To supply electrical power to the 24VDC components of SKIMO A/C unit, an optional 24VDC is available under the SNDC reference 263A03.

SKIMO 80V - converter 12V : code 263A02

 

 

 

For any piece of information on the assembly and the putting into service of Skimo contact our customer service to 05 34 480 488.